加入收藏
Hello, welcome to the company's official website !

Lock floor five techniques

2016-12-28

Lock floor the advantage of the many, many kinds, variety many lock floor is the cause of the production enterprises in order to occupy a favorable market competition advantage and applied for a patent, forcing other aggrandizement wood floor production enterprises of different level lock technology was improved.

We have learned, at present on international patent declaration lock floor there are as many as 17, but used lock technology of aggrandizement wood floor basically has the following five kinds: double lock floor --, this kind of floor tongue-and-groove has two layer, belong to the category of short lock, because it is double tongue-and-groove, tongue-and-groove thinner, higher requirements when the shop.

Hasp type lock floor --, this kind of floor is the improvement on early lock technology, tongue-and-groove and tongue-and-groove wide, about 1 cm, the front end of the tongue-and-groove is flat, can be directly inserted into the tongue-and-groove the other floors, the locking force pour tenon is on another piece of tongue-and-groove floor, relatively increased the tensile strength of the floor flat.

Long tongue type lock floor -- because of this kind of floor lock force can reach 1 ton, higher request of base material, USES the European white fir as raw materials, wooden structure uniformity, high density, strong tension, and good stability after processing, tongue-and-groove thin and long and locking force, when the shop is no point of view, the floor and floor flat taps into the slot, on the door frame and radiator edge location of the shop is more convenient.

Three-dimensional chute lock floor --, this kind of floor is on the basis of the general lock floor, in the tongue-and-groove cant increased, appeared in the junction V groove, make the long side of the floor is not easy to wear.

Angle of 45 degrees oblique insert lock floor - this kind of floor tongue-and-groove and tongue-and-groove is shorter, generally for 3 mm to 5 mm, because of tongue-and-groove pour tenon, when the shop needs certain Angle oblique thrust.